Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTION FOR USE
SOLUTION OR WASHING WATER TANK FILLING
1.
Open the water inlet cover (A, Figure 7).
2.
Fill with water or solution suitable for work performance.
The solution temperature must not exceed +104°F (+40°C).
3.
Do not overfill the tank, refer to water level indicator (B,
Figure 7) for the water volume.
WARNING!
Use only low-foam and non-flammable detergents, intended for automatic scrubber applications.
MACHINE START AND STOP
Starting the machine
1.
Prepare the machine as shown in the previous paragraph.
2.
Push the machine to the area to be cleaned, by pushing it with the hands on the handlebar (I, Figure 8).
3.
Lower the brush/pad-holder deck (M, Figure 8) and the squeegee (L) by lifting the pedal (K).
4.
Press the start switch (G, Figure 8). Check that the green warning light (C) turns on (charged battery). If the yellow (B) or red
warning light (A) turns on, Shutoff the power switch (G, Figure 8) and charge the batteries (see the procedure in Maintenance
chapter).
5.
Press the washing water flow control switches (D, Figure 8) as necessary, depending on the type of cleaning to be performed.
6.
Start cleaning by pushing the machine with the hands on the handlebar (I) and pressing the safety switch lever (J).
A B C
H
G
F
E
I
D
Figure 8
A
J
J
N
K
16
ENGLISH
B
Figure 7
M
L
Publicidad
