Hypertherm Powermax45 SYNC Guia Para Empezar página 12

Getting Started Guide
Identify problems with cut quality - mild steel
Optimal cut quality
What to look for
Lag lines with an angle of 10° – 15°
Minimal dross
Square edges
No splatter
No discolorations
Too much of a bevel angle
Possible Cause
Torch is not at a 90° angle to the workpiece
Amperage is too low
Speed is too fast
Worn cartridge
12
Solution
Align the torch at a 90° angle to the workpiece
Increase the amperage
Decrease the speed
Install a new cartridge
English Revision 0 811520MU Getting Started Guide Powermax45 SYNC