Hypertherm Powermax45 SYNC Guia Para Empezar página 9

Use the SmartSYNC hand torch
The SmartSYNC hand torch shows you when the torch is ready to cut. It also shows you when you
are in Cut mode or Gouge mode.
Torch status
GREEN
Prepared to cut or
gouge
Cut, pierce, and gouge metal
Cut
1. Start at the edge of the workpiece
2. Fire the torch
3. Drag the torch lightly across the workpiece
Powermax45 SYNC Getting Started Guide
YELLOW
Torch is locked, or a
fault occurred component is possibly faulty
.
1
. Stay at the edge until the plasma arc cuts through the workpiece.
2
1
811520MU
RED
An internal system
. Keep a stable pace. No standoff is required.
3
2
Revision 0 English
Getting Started Guide
TORCH MODE
LED OFF = cut mode
LED ON = gouge mode
3
9