Eaton TRIPP LITE Serie Manual Del Usuario página 16

1. Closure Assembly
1.3 Install the Branching Cable
1
Turn over the splice tray and remove the nut for the branching cable from the
cable hole (Figure 1-22).
Note: The cable entry is only suitable for branching cable.
2
Loosen the two screws to remove the upper press clamping (Figure 1-23).
16
04-061-93-47BC_revA.indb 16 04-061-93-47BC_revA.indb 16
Figure 1-22: Remove the nut
Figure 1-23: Remove the press clamping
1/30/2024 3:26:22 PM 1/30/2024 3:26:22 PM