1. Closure Assembly
7
Store and manage the cable (as shown in steps 17 and 18 in section 1.2
Install the Uncut Cable), then push and screw all the components for the
branching cable inward (Figure 1-28).
8
For the unused branching cable hole, loosen the nut, then insert the sealing
plug, squeeze component and the nut. Screw the nut inward to seal the hole
(Figure 1-29).
04-061-93-47BC_revA.indb 19
04-061-93-47BC_revA.indb 19
Figure 1-28: Push all the components
Figure 1-29: Seal the unused branching cable hole
19
1/30/2024 3:26:22 PM
1/30/2024 3:26:22 PM