Char-Griller FLAT IRON 8536 Manual Del Propietário página 34

Installing the Gas Cylinder
in the Grill
This appliance is only suitable for use with low-pressure propane gas
fitted with the appropriate low-pressure regulator via a flexible hose.
The hose should be secured to the regulator and the appliance with
hose clips.
1. Ensure all control knobs are in the OFF position and verify that
the gas cylinder valve is closed by turning the handle on the gas
cylinder valve clockwise until it stops.
2. Remove the protective cap from the gas cylinder valve nozzle.
3. Place the LP tank upright inside the tank hole on the bottom shelf.
4. Ensure cylinder nozzle is facing out towards you.
5. Secure LP tank by tightening (turning clockwise direction) the wing
bolt on the side off the cart.
6. Hold the regulator in a straight line with the gas cylinder valve
nozzle so the connection does not cross thread.
7. Perform a Leak Test. (See Leak Testing section of this manual).
Main Burners
Make sure there are no obstructions of airflow to gas unit. Spiders and
insects can nest within and clog the burner tube. A clogged burner tube
can lead to a fire beneath appliance.
1. Make sure all burner knobs are in OFF position and the griddle
hood is open.
2. Open valve on LP gas cylinder.
3. To ignite a burner, push in and rotate knob counterclockwise to "HI,"
then push and hold Electronic Ignition Button until burner lights. If
burner does not light in 5 seconds, turn burner OFF, wait 5 minutes
for gas to clear and repeat procedure.
4. Repeat for all desired burners. Light only burners intended for use.
5. Adjust knobs to desired cooking setting.
After lighting, observe burner flame and make sure all burner ports are lit.
PRE-HEATING NOTE: NEVER PRE-HEAT YOUR GRIDDLE ON HIGH HEAT AS IT CAN CAUSE
DAMAGE TO THE GRIDDLE SURFACE AND NEVER LEAVE YOUR GRIDDLE UNATTENDED
Proper pre-heating will ensure the best cooking performance for your griddle. Always pre-heat your
griddle on the medium or medium-low setting for five minutes and then turn to high heat or desired
temperature level.
If burner flame goes out during operation, immediately turn gas off on control panel and gas cylinder
valve. Let gas clear for 5 minutes before relighting. Clean griddle after each use. DO NOT use
abrasive or flammable cleaners, as they damage parts and may start a fire.
C-3