SKF FlowMaster II Guía De Usuario Y Mantenimiento página 5

Safety *
The assembly must be installed, maintained
and repaired exclusively by persons familiar
with the instructions
Always disconnect power source
(electricity, air or hydraulic) from the
equipment when it is not being used
This equipment generates high pressure
Extreme caution should be used when
operating this equipment as material leaks
from loose or ruptured components can
inject fluid through the skin and into the
body If any fluid appears to penetrate the
skin, seek attention from a doctor
immediately Do not treat injury as a simple
cut Tell attending doctor exactly what type of
fluid was injected
Any other use not in accordance with
instructions will result in loss of claim for
warranty or liability
• Do not misuse, over-pressurize, modify
parts, use incompatible chemicals, fluids,
or use worn and/or damaged parts
• Do not exceed the stated maximum
working pressure of the equipment or of
the lowest rated component in your
system
• Always read and follow the manufacturer's
recommendations regarding fluid
compatibility, and the use of protective
clothing and equipment
• Failure to comply may result in personal
injury and/or damage to equipment
* Indicates change
Explanation of signal
words for safety
NOTE
Emphasizes useful hints and
recommendations as well as
information to prevent property damage
and ensure efficient trouble-free
operation
CAUTION

Indicates a dangerous situation that can
lead to light personal injury if
precautionary measures are ignored
WARNING

Indicates a dangerous situation that
could lead to death or serious injury if
precautionary measures are ignored
DANGER

Indicates a dangerous situation that will
lead to death or serious injury if
precautionary measures are ignored
WARNING

Do not operate equipment
without reading and fully
understanding safety
warnings and instructions
Failure to follow warnings and
instructions may result in serious injury
5
CAUTION

Do not operate equipment without
wearing personal protective gear
Wear eye protection Protective
equipment such as dust mask, non-skid
safety shoes, hard hat, or hearing pro-
tection used for appropriate conditions
will reduce personal injuries
Failure to comply may result in light
personal injury
WARNING

Do not allow any body part
to be trapped by equipment
Body parts can be crushed
by subassemblies during
operation
Failure to comply may result in death
or serious physical injury
WARNING

Do not allow fluid to leak
onto floor when operating
equipment If spill occurs,
clean any fluid on floor before continuing
operation
Failure to comply may result in death
or serious personal injury
WARNING

Do not use this equipment to supply,
transport, or store hazardous
substances and mixtures in accordance
with annex I part 2-5 of the CLP
regulation (EG 1272/2008) or HCS 29
CFR 1910 1200 marked with GHS01,
GHS06 and GHS08 hazard pictograms
shown: