Tabla de contenido
Publicidad
R
24
2.3.2-1
2.3.2-2
P
N Q
M
L
S
2.3.2-3
monty 3550
2.3.2 Installing the Kit: EAA0304G80A - RAPID
CHANGE-OVER KIT FOR TOOL WITH +4"
EXTENSION
WARNING
BEFORE INSTALLATION, DISCONNECT THE
TIRE CHANGER FROM THE ELECTRICITY AND
COMPRESSED AIR SUPPLIES.
Preliminary operations
See Figure 2.3.2-1
1) Remove the two screws (A) from the tool fi tted on the
tire changer.
2) Unscrew and remove the fi xing screw (B) underneath
the tool.
3) If the tire changer has a mechanical lever for locking
the hexagonal rod, operate the lever to clamp the rod.
Memorise the position of the tool, then remove it from
the hexagonal rod.
N.B.: The hexagonal rod will have to be held back by hand
to prevent the vertical spring from pushing it out upwards.
Installing the Kit
See Figure 2.3.2-2
4) Insert the threaded ring nut (C), the washer 41x53x2
(D) and place the connection bush (E) on the hexagonal
rod, positioned so that the holes for the adjuster screws
are facing upward and in line with the holes in the rod.
5) Screw in the screw 10x20 (G) by hand, without
tightening, also fi tting the washer 10x32 (H).
6) Screw in the two screws (F) supplied in the kit by the
same amount, without tightening, so that the bush remains
centred.
7) Tighten the screws (F) fully, tightening them by small
amounts in turn, then to conclude tighten the screw
underneath (G).
Installing the tool supplied in the Kit
See Figure 2.3.2-3
8) Fit the tool supplied in the Kit (L) on the snap connection
for the extension, positioned so that the adjuster screws
(M) are in line with the seats (N) on the hub of the
connection.
9) Screw in the screws (M) on the tool by the same amount,
without tightening fully.
10) Screw in the screw 10x30 (S) with the washer 10x38
(R) by hand, without tightening fully.
11) Fit the assembly formed as described onto the bush
previously fi tted. Tighten the ring nut with the wrench
supplied in the kit (Q).
N.B.: Place the tool in the same position as the original
removed from the tire changer.
Publicidad
Tabla de contenido
