Tabla de contenido
Publicidad
2
42
monty 3550
4.3-1
4.3-2
4.3-3
4.3-4
Beading with the GP device:
The machine can be provided with a GP device, neces-
sary for bead seating of tubeless tires.
(Figure 4.3-2)
•
If possible lock the wheel from inside. Outside locking
reduces effi ciency of the bead seater.
•
Connect the compressed air hose to the valve (2).
•
Lift the tire with both hands so that upper bead is sealed
to the rim edge (Fig. 4.3-2).
•
Press the infl ation pedal (1) down swiftly. The top
bead is already sealed by the lifting motion. The air
from the bead seater jets will rebound into the bot-
tom sidewall driving it into place and creating a seal.
STOP THE COMPRESSED AIR AS SOON AS THE
BEADS GRIP THE RIM WELL.
•
Place the wheel in a type approved cage to fi nish
infl ating and completely settle the beads in their seats
on the rim.
(Figure 4.3-3)
WARNING: WHEN OPERATING THE BEADING DEVICE
IT IS COMPULSORY TO WEAR EAR DEFENDERS TO
PROTECTAGAINST NOISE AND SAFETY GOGGLES
TO PREVENT ANY CONTAMINATION BY DUST AND
OTHER IMPURITIES BLOWN BY THE AIR JETS.
4 . 4 M o u n t i n g a n d D e m o u n t i n g
Motorcycle Tires
To mount and demount motorcycle, motor scooter or
ATV tires it is necessary to utilize the optional adaptors
kit (EAA0329G53A) (Figure 4.3-4) and the small-wheel
bead breaker blade.
The bead breaking, mounting and demounting technique
is the same as per car tires.
NOTE: If the top tire bead is diffi cult to mount, see
paragraph 4.2.1.
WARNING!
MOTORCYCLE RIMS MUST ALWAYS BE CLAMPED
FROM THE OUTSIDE.
Publicidad
Tabla de contenido
