Hofmann monty 3550 Manual De Operador página 30

Desmontadora de neumáticos electrónica-neumática / neumática
Ocultar thumbs Ver también para monty 3550:
Tabla de contenido

Publicidad

1062.tif
30
monty 3550
4,5 bar
1115.tif
1118.tif
3.0-4
Only for Tubeless wheel models:
F1.
Press bead seater/infl ator pedal (1, Fig. 3.0-3) on
left side of the machine half way down: air will come from
infl ation hose end only (2, Fig. 3.0-3).
F2. Press bead-seater pedal down swiftly to get air blast
from the infl ator jets. Air simultaneously comes out of
infl ator hose (2, Fig. 3.0-3).
Note: Air simultaneously continues to exit the hose
connected to the tire.
WARNING:
ONCE BEADING IS COMPLETE, IMMEDIATELY STOP
INTRODUCING AIR.
WHEN OPERATING THE BEADING DEVICE IT IS
MANDATORY TO WEAR EAR PROTECTORS AND
SAFETY GLASSES TO PREVENT CONTAMINATION
FROM NOISE, DUST AND CHIPS BLOWN BY THE
AIR JET.
DANGER OF TIRE EXPLOSION
Note: For safety reasons a quick-infl ating valve preset to
4,5 bar is fi tted upstream of the pressure gauge for the
pedal-operated infl ating device.
Presetting of clamping jaws:
H. The turntable jaws can be positioned in two different
way. Push the lever (C) on the left side of each jaw and
shift at the same each one (0/+4") (Fig. 3.0-4).
N.B.: Turntable capacity can be changed before pedal
control.
VERY IMPORTANT: LOOK FOR PROPER INSER-
TION OF THE PIN
CAUTION! MAKE SURE ALL FOUR CLAMPING
JAWS ARE MOUNTED IDENTICALLY (1 OR 2, FIG.
3.0-4). OTHERWISE THE RIM MAY COME LOOSE
AND INJURE THE OPERATOR!
Rim diameters are shown in inches on the turntable (A,
Fig. 3.0-4). The diameter setting (mark on jaw (B) must
coincide with mark on turntable) depends on the clamp-
ing jaw position 1 or 2.
• In jaws position 1 the diameter is preset directly (1, Fig.
3.0-4).
• In position 2 (2, Fig. 3.0-4) 4" must be added to the
diameter.

Publicidad

Tabla de contenido
loading

Tabla de contenido