Tabla de contenido
Publicidad
C
22
R
A
B
2.3.1-1
D
E
2.3.1-2
monty 3550
2.2 Air Installation
WARNING
THE AIR INSTALLATION MUST BE MADE ONLY BY
LICENSED PERSONNEL.
WARNING
EXCESSIVE AIR PRESSURE CAN SERIOUSLY INJURE
PERSONNEL AND DAMAGE THE MACHINE.
Ensure that the line pressure is within the limits required
by the machine. If the air pressure exceeds 12 bar (170
psi) it is mandatory to install a pressure regulator before
the air inlet of the machine
It is suggested that the air supply be equipped with a water
separator and air lubricator.
After ensuring all the above proceed as follows:
A.
Connect the machine to the air supply with a rubber hose
equipped with 1/4"NPT treaded junction.
WARNING
BEFORE CONNECTING THE MACHINE TO THE AIR
SUPPLY BE SURE ALL PERSONNEL ARE CLEAR OF
THE MACHINE AND THAT NOTHING IS LEFT ON THE
TURNTABLE AREA (TOOLS)
B. Should you install any optional accessories, please
refer to the relevant instructions.
2.3 Accessories Installation
2.3.1
Installing the Kit: EAA0332G91A -
SLIDING JAW +4 INCH KIT
WARNING
BEFORE INSTALLATION, DISCONNECT THE
TIRE CHANGER FROM THE ELECTRICITY AND
COMPRESSED AIR SUPPLIES.
See Figure 2.3.1-1
1) Remove the standard jaws (R), present on the tire
changer turntable.
2) Insert the +4" jaws supplied in the kit on the turntable
sliding parts and align the side holes (A) with the holes
(B) in the sliding parts.
CAUTION: SECURE THE SLIDING PARTS WITH BOTH
SCREWS IN THE HOLES PREPARED.
See Figure 2.3.1-2
3) Insert the screws (C) in the side holes in the jaws, put
the washers (D) on the opposite side and secure with
the nuts (E).
NOTE: If the holes (B) in the sliding parts are blocked by
dirt, clean them by MANUALLY inserting an 8 mm diameter
spiral bit in them several times.
CAUTION: AFTER INSTALLATION, THE JAWS MUST
BE EQUIDISTANT FROM THE CENTRE OF THE
TURNTABLE.
Publicidad
Tabla de contenido
