Cybex Platinum ANORIS T2 i-SIZE Guia Del Usuario página 12

REMOVAL FROM TH E VE H ICLE
EN
1. Unlock the ISOFIX Locking arms (7) on both sides by pressing the ISOFIX
Release buttons (6) and at the same time pulling them back.
2. Remove the car seat and slide the ISOFIX Locking arms (7) completely back
into their transport positions.
3. By pressing the load leg adjustment button (10) push the load leg (4) back
and then fold it in to save space.
ADJUSTING THE H EAD R E ST
The headrest (12) can be adjusted by using the headrest adjustment handle (13).
When adjusting the headrest (12) ensure that a maximum of 2 cm (approx. 2 fin-
ger's width) remain between the child's shoulders and the headrest.
ADJUSTING THE RECLINE POS ITION
To adjust the car seat to the desired recline position, press the position adjustment
handle (14) on the front of the car seat.
�� Always make sure the car seat audibly clicks into place when adjusting it to the
desired recline position.
SECURING TH E CH I LD
1. Release the impact shield (15) by pressing the adjuster button (16) and simul-
taneously pull the impact shield forward.
2. Release the belt buckle (17) of the impact shield (15) by pressing the red re-
lease button of the car seat and place the impact shield next to the car seat.
3. Put your child into the car seat.
4. Place the impact shield (15) back and plug the belt tongue (18) of the impact
shield into the corresponding belt buckle (17) of the car seat. Make sure that
the buckle locks into place with an audible "CLICK". The impact shield indica-
tor (20) switches to GREEN.
5. Pull on the impact shield (15) to check whether the belt buckle (17) has
locked into place correctly.
6. Press the adjustment button (16) and push the impact shield (15) towards the
child. The impact shield (15) must fit tightly at the child's body and pelvis.
�� Each time the child is fastened, check that the impact shield fits correctly.
7. Before starting the journey check that all indicators on the display panel (5)
are GREEN by pressing the check button (19).
8
INFORMATION AND INSTRUCTIONS FOR TH E AI R BAG
The car seat's airbag is located inside the impact shield and provides additional
safety in the event of an accident.
The following conditions must be met for the airbag of the car seat to be active:
•
The battery charge status is sufficient.
• The car seat is installed correctly and the impact shield buckled in.
•
All indicators on the display panel are lit up GREEN.
BATTERY MANAG E M E NT
Depending on the battery life and usage behaviour, it may be necessary to change
the batteries. If the batteries are empty, the airbag and the indicators and warning
signals are not active.
A warning signal indicates that the batteries must be replaced.
To change the batteries, you have to open the battery compartment (3) with a
suitable tool. After changing the batteries, this compartment must be closed
again. The Battery indicator on the display panel will light up GREEN. If the dis-
play panel does not light after exchanging the batteries please contact the retailer
or manufacturer.
Only use the recommended type CR17450 batteries (3V DC).
•
Do not reverse the positive and negative terminals when mounting.
• Only use identical and new batteries without damage.
• Always remove the empty batteries.
•
Keep all batteries out of reach of children.
• Do not charge the batteries.
• Do not subject the batteries to severe shock.
•
Never expose this product or the batteries to fire.
• Do not store the batteries in a hot and humid environment.
•
Do not disassemble the batteries. Do not short-circuit the batteries.
•
Remove the batteries in case of longer storage.