Dual Post Height Adjustable Armrest - Ki Mobility FOCUS CR Manual De Instrucciones

V. SET UP & USE OF YOUR WHEELCHAIR
D. Dual Post Height Adjustable Armrest
1. Installation
a. Ensure both levers (Fig. 4:A and B) are flipped upward.
b. Set both posts of armrest into receivers until they are seated against the bottoms of the
receivers.
c. Flip levers back downward. Ensure locking pins are seated by lifting on armrest.
2. Height Adjustment
a. Flip lever (Fig. 4:C) forward at the top of the front post of the lower frame of the armrest.
b. Adjust height of armrest by pushing down or pulling upwards on arm pad near the center
between the two posts of the armrest.
c. When proper height is achieved, flip lever rearward again and move armrest up or down to
allow pin to seat in nearest hole.
3. Flipping Back Armrest
a. Flip lever (Fig. 4:A) on front armrest receiver.
b. Lift upwards on arm pad and cross tube, allowing the armrest to flip back.
NOTE: Do not push outward or backward on armrest when it is flipped back or damage to rear
receiver may occur.
4. Removal
a. Flip the levers (Fig. 4:A and B) on both receivers upward.
b. Lift armrest out of receivers by pulling up on arm pad and cross tube.
Fig. 4
A
B
19
C