Swing Away Hangers - Ki Mobility FOCUS CR Manual De Instrucciones

V. SET UP & USE OF YOUR WHEELCHAIR
G. Swing Away Hangers
1. Installation
a. Place swing away pivot saddle into the receiver on front frame tube with the footrest facing
either inward or outward from the frame (Fig. 6).
b. Rotate the footrest so that it aligns with the frame until it locks into place in the latch block
(Fig. 7).
2. Swinging the Footrest Away
a. Push release latch toward the frame.
b. Rotate footrest outward or inward as desired.
3. Removal
a. To remove footrest, push release latch toward the frame.
b. Lift the footrest straight upward to remove. You may also swing the footrest inward or out-
ward before lifting it off.
Fig. 6
WARNING: Always make sure the hangers are locked in place before using them or riding the
wheelchair. Failure to do so may result in a fall or loss of control and may cause serious injury or
death.
DANGER: Never attempt to lift the chair by the hangers; they may break or disconnect resulting
in a fall or loss of control and may cause serious injury or death.
21
Fig. 7