Wheel Locks - Ki Mobility FOCUS CR Manual De Instrucciones

V. SET UP & USE OF YOUR WHEELCHAIR
S. Wheel Locks
1. Adjusting Wheel Locks
a. Use a 10mm wrench or socket to loosen (do not remove) hex bolt (Fig. 40:A) beneath
mounting block of base frame.
b. Slide mount plate (Fig. 40:B) forward or rearward to achieve proper locking.
c. Retighten hex bolt.
2. Reversing Wheel Lock Mount
a. Using a 10mm wrench, remove the nuts (Fig. 40:C) from the wheel lock studs and remove
wheel lock mechanism (Fig. 40:D).
b. Remove hex bolt (Fig. 40:E) and nut (Fig. 40:F) using 10mm wrenches.
c. Flip wheel lock mount (Fig. 40:G) forward or reverse.
d. Reinstall and tighten hex bolt (Fig. 40:E) and nut (Fig. 40:F).
e. Reinstall wheel lock mechanism (Fig. 40:D) and fasten with nuts (Fig. 40:C). Note that large
diameter washer (Fig. 40:H) goes beneath the nut that covers the scalloped hole (Fig. 40:I).
Always install the wheel lock using the scalloped hole that allows the front stud of the wheel
lock mechanism to lie below the rear stud, i.e., if the single hole is toward the front of the
chair, install wheel lock to that the rearmost stud of the wheel lock mechanism is in the
upper hole of the scalloped hole. If the single hole is toward the rear of the chair, place the
front stud of the mechanism in the lower hole of the scalloped hole.
f. Note that if the chair is equipped with attendant foot lock and you are changing the wheel
size, you will need to obtain a new linkage rod. Please contact Ki Mobility Customer Service
to order.
C
F
H
G
B
A
38
Fig. 40
D
I
E