Kärcher IVR 40/15 Sc Manual Del Usuario página 16

Suction process
See graphics page for illustrations
Illustration D
Holder
1
Suction hose
2
Accessory holder
3
Nozzle
4
1. Switch the device on.
2. Remove the suction hose from the hold-
er.
3. Take the desired nozzle out of the ac-
cessory holder and attach it to the suc-
tion hose.
4. Vacuum up the desired material.
5. Take the nozzle off the suction hose and
place it into the accessory holder.
6. Place the suction hose on the holder.
7. Switch off the device.
Cleaning the dust filter
See graphics page for illustration
Note
Clean the filter regularly to avoid declining
suction power.
Illustration E
1. Move the filter cleaning handle back and
forth several times to clean the filter.
Reading the minimum volumetric
A gauge is mounted on the front of the de-
vice that shows the vacuum intensity.
(see chapter Device description)
The table shows the maximum vacuum in-
tensity value. This value depends on the
unit performance and the suction hose
used.
ATTENTION
Suction loss
If the specified value is exceeded, the air
speed in the suction hose drops below
20 m/s.
Clean the bag filter when the value is
reached, or sooner.
If cleaning does not significantly lower the
value, change out the bag filter.
(see chapter Replacing the pocket filter)
16
flow

Power Hose diame-
ter
1.5 kW DN40
3.0 kW DN40
3.0 kW DN50
4.0 kW DN40
4.0 kW DN50
 Clean the filter before or when the spec-
ified value is reached.
Emptying the collection container
See graphics page for illustrations
1. Switch the device off and disconnect it
from the power supply.
2. Clean the dust filter.
3. Push down the lever to lower the collec-
tion container.
Illustration F
4. Pull the collection container out of the
device.
Illustration G
5. Empty the collection container into the
waste container.
6. Dispose of or reuse the contents in ac-
cordance with applicable law.
7. Empty the collection container after
each use and otherwise as needed.
Note
Only move the collection container only on
its rollers. Do not use a crane, forklift or sim-
ilar means.
Remove PE dust bag
See graphics page for illustrations
Illustration H
1. Disconnect the pressure equalisation
hose from the collection container.
2. Take the collection container out of the
device.
3. Remove the fastener from the PE dust
bag.
4. Close the PE dust bag using a cable tie
or adhesive tape.
5. Dispose of the dust bag in accordance
with statutory regulations.
English
Value
126 mbar
(12.6 kPA)
200 mbar (20 kPA)
150 mbar (15 kPA)
226 mbar
(22.6 kPA)
216 mbar
(21.6 kPA)