Publicidad
Idiomas disponibles
Idiomas disponibles
Display indicators
Delayed start function is activated.
To cancel the setting.
5. BEFORE FIRST USE
WARNING!
Refer to Safety chapters.
5.1 Initial cleaning
1. Remove all accessories and removable
shelf supports from the appliance.
2. Clean the appliance and the accessories
only with a microfibre cloth, warm water
and a mild detergent.
3. Put the accessories and removable shelf
supports back to their initial position.
5.2 First connection
The display shows welcome message after
the first connection.
You have to set: Language, Display
Brightness, Key Tones, Buzzer Volume,
Water Hardness, Time of Day.
5.3 Wireless connection
To connect the appliance you need:
• Wireless network with the Internet
connection.
• Mobile device connected to the same
wireless network.
1. To download My AEG Kitchen app: Scan
the QR code located on the rating plate
with the camera on your mobile device to
be redirected to AEG Homepage.
The rating plate is located on the front
frame of the appliance cavity. You can
also download the app directly from the
app store.
2. Follow the app onboarding instructions.
3. Turn on the appliance.
4. Press
. Select: Settings / Connections.
5.
- slide or press to turn on or off: Wi-Fi.
The appliance wireless module starts within
90 sec.
Display indicators
Wi-Fi connection is turned on.
Remote Operation is turned on.
For safety reasons, remote operation
turns off automatically after 24 h. Repeat
the onboarding, if needed.
Frequency
2.4 GHz WLAN
2400 - 2483.5 MHz
Protocol
IEEE 802.11b DSSS, 802.11g/n
OFDM
Max Power
EIRP < 20 dBm (100 mW )
Wi-Fi module
NIUS-50
5.4 Software licences
The software in this product contains
components that are based on free and open
source software. AEG acknowledges the
contributions of the open software and
robotics communities to the development
project.
To access the source code of these free and
open source software components whose
license conditions require publishing, and to
see their full copyright information and
applicable license terms, visit: http://
aeg.opensoftwarerepository.com (folder
NIUS).
5.5 Initial preheating
Before the first use, preheat the empty
appliance.
1. Remove all accessories and removable
shelf supports from the appliance.
2. Set the function
temperature.
Let the appliance operate for 1 h.
3. Set the function
temperature.
. Set the maximum
. Set the maximum
ENGLISH
9
Publicidad
