Publicidad
Idiomas disponibles
Idiomas disponibles
Remote control. Fig. 4
1.
Power button
2. Reverse button
3. Timer button
4. Light button
5. Lock button
6. Speed increase button
7.
Speed decrease button
Note: this is a wireless remote control.
To pair the remote control, first connect the fan to the mains. When you do so, you will hear a
beep and the appliance will enter standby mode. Then, press the power button and choose the
speed. The information on the display will flash for 8 seconds. Press any button on the remote
control and you will hear a beep, indicating that pairing has been completed successfully.
NOTE: before using the fan, remove the film covering the battery.
Press it to switch on/off the fan.
Press it to change air direction. Air will come out of the top or the bottom.
Press it to set the timer. Each time you press it, one hour of operation will be added.
The timer can be set from 1 to 8 hours. If you switch off the fan, the timer will be
deactivated.
Press it to switch on the light (1/2/3).
Press these buttons to adjust the fan speed.
50° adjustment angle. Fig. 5
When adjusting the angle, hold the tube at the same time. This will prevent the amplitude of
the oscillation from becoming too large.
WARNING: adjusting the movable joint part of the product to a T-degree will result in damage
to the joint function.
ENGLISH
ENERGYSILENCE FANLAMP
41
Publicidad
