Publicidad
Idiomas disponibles
Idiomas disponibles
b)
Disconnect the device from the power supply before commencement of adjustment,
cleaning and maintenance. Such a preventive measure reduces the risk of accidental
activation.
c)
When not in use, store in a safe place, away from children and people not familiar with the
device who have not read the user manual. The device may pose a hazard in the hands of
inexperienced users.
d)
Keep the device in perfect technical condition. Before each use check for general damage,
especially check moving components for cracked parts or elements, and for any other
conditions which may impact the safe operation of the device. If damage is discovered, hand
over the device for repair before use.
e)
Keep the device out of the reach of children.
f)
Device repair or maintenance should be carried out by qualified persons, only using original
spare parts. This will ensure safe use.
g)
To ensure the operational integrity of the device, do not remove factory-fitted guards and do
not loosen any screws.
h)
When transporting and handling the device between the warehouse and the destination,
observe the occupational health and safety principles for manual transport operations which
apply in the country where the device will be used.
i)
Avoid situations where the device stops working during use due to excessive loading. This
may result in overheating of the drive elements and damage to the device.
j)
Do not touch articulated parts or accessories unless the device has been disconnected from
the power source.
k)
Do not move, adjust or rotate the device in the course of work.
l)
Clean the device regularly to prevent stubborn grime from accumulating.
m) The specified vibrations emission was measured using standard measurement methods.
Vibrations emissions may change if the device is used in different surroundings.
n)
The device is not a toy. Cleaning and maintenance may not be carried out by children without
supervision by an adult person.
o)
Do not run the device when empty.
p)
It is forbidden to interfere with the structure of the device in order to change its parameters
or construction.
q)
Keep the device away from sources of fire and heat. Do not expose the device to direct
sunlight.
r)
Do not cover the ventilation openings!
s)
NOTE: During operation, some elements of the device become very hot – scalding hazard!
t)
Do not place the device upside down or tilt it at an angle greater than 45°.
u)
Keep a free space around the device (at least 50 cm on each side).
v)
Do not damage the refrigerant circulation system.
w) Prevent water and other liquids from entering the device;
x)
If there is no mixture or water in the freezing cylinder, the machine cannot operate. Failure
to follow this recommendation may result in damage to the mixer.
y)
Do not insert any objects into the ventilation grill or dispenser outlet while the machine is
running
z)
The device contains flammable materials. After completely ceasing to use the device, it
should be transferred to a facility dealing with the safe disposal of electronic and hazardous
equipment.
aa) If the cylinder in the machine freezes, unplug the power, wait 30 minutes, then turn on the
power and run the whipping function on a lower setting, then activate the cooling mode. If
the machine has a defrost function, you can start it directly without turning off the power.
ATTENTION! Despite the safe design of the device and its protective features, and despite
the use of additional elements protecting the operator, there is still a slight risk of
EN
Publicidad
