Publicidad
Idiomas disponibles
Idiomas disponibles
• Please ensure that the power supply to the device corresponds to the data given on the
nameplate!
• The use of extension cords is not recommended;
• Do not change the original plug;
• Do not use a plug adapter;
• The device should be connected to an outlet that has a grounding wire.
• Before first use, dismantle all components and wash them, as well as wash the entire device.
Test run
1) Connect the machine to the power supply.
2) Press the "CLEAN" button, the mixer will start rotating
3) Press the "AUTO" button, the mixer will rotate and a few minutes later the compressor will
start freezing.
4) Press the "STANDBY" button, wait 2-3 minutes and then check whether the tank has stopped
freezing.
NOTE : Do not allow the device to run dry for a long time (without ice mixture), as this may damage
the device.
Cleaning before first use
Before first use, please clean and disinfect the machine thoroughly by following these steps:
1) Prepare 3 liters of a solution consisting of a mixture of cold water and cleaning detergent
intended for use on surfaces in contact with food. Pour the solution into the machine's tank
and clean the tank thoroughly using a sponge or soft cloth.
2) Turn on the power, press the "CLEAN" button and let the machine run for 2 minutes.
3) Place a bucket under the dispenser opening, pull the handle down to pour out the solution.
4) Once all the cleaning solution has drained, press the "CLEAN" button to exit the cleaning
mode.
5) Rinse the tank and dosing system by repeating all washing steps 2-3 times, using only clean
water.
ATTENTION
•
The temperature of the solutions should be below 60°C, otherwise it will damage the parts.
•
After cleaning, make sure there is no water in the cylinder, otherwise the frozen ice will
damage the agitator when the machine freezes.
3.3.
Parameter settings
1) Serving counter check and reset function : To check how many servings have been
dispensed, press the "UP" and "DOWN" buttons simultaneously. The function only works in
automatic mode and counts when the microswitch is active. The counter will return to its
previous display if you do not perform any action for 5 seconds. You can reset the counter by
pressing the "UP" and "DOWN" buttons simultaneously for 5 seconds.
2) Ice hardness setting : In standby status, press the "UP" button for 1 second to activate the
hardness setting mode (the "HARD/SET" window will flash). Then, use the "UP" or "DOWN"
buttons to select the ice hardness level from 1 to 10. The setting will be saved automatically
after 5 seconds of inactivity.
3) Checking the temperature : To check the temperature inside the device, press and hold the
"UP" button for 3 seconds. This will allow you to read the temperature of the upper tank and
cylinder.
4) Setting System Parameters : To adjust system settings, hold "SET" button for 3 seconds.
Then, scrolling through options P0 to P5 with short presses on "SET", select the parameter to
EN
Publicidad
