Warning And Information Signs En; Product-Specific Hazards En; Emergency Information En - Abicor Binzel iROB P400 Instructivo De Servicio

2 Safety
2.6 Warning and information signs
Following warning and information signs are located on the product:
Symbol
These markings must always be legible. They may not be covered, obscured, painted over or removed.
2.7 Product-specific hazards
• Check the electrical device for any damage and for proper functioning in accordance with its
designated use.
• Never expose the electrical device to rain and avoid a moist or wet environment.
• Protect yourself from electrical accidents by using insulating mats and wearing dry clothing.
• Never use the electrical device in areas subject to fire or explosion hazards.
• Arc welding may cause damage to eyes, skin and hearing! When working with the device, always
wear the prescribed protective equipment.
• Any metal vapours, especially lead, cadmium, copper and beryllium are harmful to health! Ensure
sufficient ventilation or extraction. Always ensure compliance with the legal limit values.
• Rinse work-pieces that have been degreased with chlorinated solvents with clear water. Otherwise there
is a risk of phosgene gas formation. For the same reason, no degreasing baths containing chlorine must
be placed in the vicinity of the welding area.
• Adhere to the general fire protection regulations and remove flammable materials from the surroundings
of the welding work area, prior to starting work. Keep appropriate fire extinguishing equipment ready
at the workplace.
2.8 Emergency information
In case of emergency, immediately interrupt the following supplies:
• Electricity, compressed air, gas
• Further measures can be found in the "Power source" operating instructions or in the documentation of
further peripheral devices.
EN - 6
Meaning
Read and observe operating instructions!
iROB