Putting Out Of Operation - Abicor Binzel iROB P400 Instructivo De Servicio

8 Putting out of operation

Symbol Pos. Designation
(8) Connection for iCONTROL.
(9) Voltage during welding/ error codes.
1 Dummy cover connecting socket for
robot interface RI 1000/2000/3000
2 Dummy cover connecting socket for torch
cleaning station
Fig. 8 Rear view
Symbol Pos. Designation
(3) Connection (CAN BUS)
(5) Control lead connection intermediate cable assembly
(6)
Positive connection for welding current
(7) Negative connection for welding current (ground cable)
8 Putting out of operation
NOTICE
• Observe the operating instructions of the welding components, such as the coolant recirculator
1 Disconnect the robot welding power supply iROB from the mains on the main switch (6) .
 Fig. 7 Front view on page EN-17
EN - 18
1
7
3 CAN bus
4
Connecting cable passage
5 Control lead connecting socket for
intermediate cable assembly
iCOOL, wire feeder iFEED, remote control iCONTROL and welding torch.
2 3
4
5
6
6 Positive connecting socket for welding current
7
Negative connecting socket for welding current
iROB