Dismounting; Disposal - Abicor Binzel iROB P400 Instructivo De Servicio

11 Dismounting

11 Dismounting
Risk of injury due to unexpected start-up
For the entire duration of maintenance, servicing, mounting, dismounting and repair work, the following
instructions must be adhered to:
• Switch off the power source.
• Pull the mains plug.
NOTICE
• Dismounting may only be carried out by qualified personnel (in Germany see TRBS 1203).
• Please observe the operating instructions of the welding components, coolant recirculator iCOOL
• Observe the information given in the following chapter:
 8 Putting out of operation on page EN-18.
1 Disconnect the intermediate cable assembly and the connections to connected parts.
Risk of injury
Limbs can be crushed and cut.
• Use an appropriate lifting tool with load securing devices for transport and installation.
NOTICE
• Use an appropriate crane with suitable load securing devices for transport and installation of the
• Observe the safety instructions of the crane manufacturer.
2 Option: Cooling unit
Electric shock
Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation and damage.
• Replace any damaged, deformed or worn parts.
• Observe the information given in:
 BAL.0332.0 Coolant recirculator iCOOL
3 Remove parts to be disconnected.

12 Disposal

For disposal, observe the local regulations, laws, provisions, standards and guidelines. Observe the
guidelines for the disposal of electronic scrap and dispose of it at your communal waste disposal authorities
(e.g. recycling yard).
For the product to be properly disposed of, it first must be dismounted.
 See 11 Dismounting on page EN-22
EN - 22
DANGER
(option), wire feeder iFEED (option), remote control iCONTROL (option) and welding torch.
WARNING
iROB robot welding power source.
DANGER
iROB