Audiolab LIVE 16XL Manual De Usuario página 29

DSP Control
Touch Main & Sub1-4 on the LCD screen or corresponding
button on the panel to assign input channel audio to these
channels or buses. They will illuminate synchronizing with
buttons in Assign area on the panel after pressed. To adjust
output level of the channel audio, you can rotate Parameter
Adjust knob or corresponding Main or Sub1-4 knobs on the
right corner of the panel.
Touch AUX1-4 and FX1-2 on the LCD screen or press corre-
sponding button on the panel to assign input channel audio to
these channels or buses. To adjust output level of the channel
audio, you can rotate Parameter Adjust knob on the panel.
Touch PRE on the screen, it will switch to POST, the AUX & FX
send will derive its signals from all channels post-fader. If the
icon has not been pressed and not illuminate, by default, the
AUX & FX Send will derive its signal from all channels pre-fad-
er and all unaffected by the sending channel's fader position.
In a word, touch PRE and switch it to POST, then you can ad-
just its level by sliding fader. Otherwise, the fader wouldn't
function on level adjustment.
LIVE 16XL
ENGLISH VERSION
Slide the fader to change selected input
channel audio. The fader function is the
same with Fader on the panel, which can
control input signal's level, they will change
synchronously. Meter beside it indicates
the signal level activity.
Pan above fader indicates value of pan set-
ting. Solo can monitor selected channel
audio. Mute can silence selected channel
audio. Long press CH01 can rename the se-
lected channel.
Adjust this parameter to change selected
output channel audio. This fader function is
the same with Parameter Adjust knob, they
will change synchronously.
p. 29