Audiolab LIVE 16XL Manual De Usuario página 32

DSP Control
Touch this control, it will illuminate as well as the button, sig-
nal from a selected channel can be assigned to Main channel,
for the details please refer to Assign introduction in section 6.3.
Touch the switch ON to enable Gate function, then rotate
Parameter Adjust knob or slide long fader on the right LCD
screen to adjust value of Threshold, which will show in the
middle box. During adjustment, corresponding figure change
will show in the Gate grid.
In this area, you can touch the grid area to enter Gate page,
for the detail of Gate function, please refer to the Gate intro-
duction in section 6.5.
Touch the switch ON to enable EQ function, it will illuminate
and synchronize with ON/OFF control in EQ page. Please set
values in EQ page because it is not adjustable here. This page
can only show the values. You can also load a preset, please
refer to load introduction section for the detail operation, the
loaded state will show in the middle box.
Touch Flat EQ to eliminate EQ settings and restore it to de-
fault. In this area, you can touch the grid area to enter EQ
page, for the detail of EQ function, please refer to the EQ in-
troduction in section 6.7.
LIVE 16XL
ENGLISH VERSION
Touch the switch to enable Compressor function, then rotate
Parameter Adjust knob or slide long fader on the right LCD
screen to adjust value of Threshold, which will show in the
middle box. During adjustment, corresponding figure change
will show in the Compressor grid.
In this area, you can touch the grid area to enter COMP page,
for the detail of COMP function, please refer to the COMP in-
troduction in section 6.6.
Touch anyone of these controls to enter corresponding page.
It is the same with that in Assign interface in section 6.3.
Note: you can also rename the selected channel by long
pressing CHXX.
p. 32