Audiolab LIVE 16XL Manual De Usuario página 36

DSP Control
6.7 EQ interface
Touch the switch to engage or disengage the equalizer for the
selected channel. It will illuminate to indicate that the equal-
izer has been touched and enabled. The LCD display shows
the EQ setting in real time. Its parameters can adjust by slid-
ing the curve on the screen directly or using up & left & down
& right key to choose the function that you want to modify
and use the Parameter Adjust knob to set the value.
Please notice that only if the EQ button has been enabled can
its parameters be adjusted. The equalizer is available for all
input and output buses.
Touch it, a dialog box saying " Are you sure to flat the EQ?"
will prompt to check with you, if you click "yes", all the setting
values in this page will restore to default, while choose "no"
can keep your settings.
Touch it to set the center frequency of the equalizer's Low/
Low-mid/High-mid/ High band separately. The center fre-
quency is the middle of the pass-band between the lower
and upper cutoff frequencies which define the limits of the
band. The center frequency can be set from 20Hz to 20K Hz.
LIVE 16XL
ENGLISH VERSION
Touch it to set the Q for the Low/Low-mid/High-mid/High
band separately. The Q is the ratio of the center frequency to
the bandwidth. If the center frequency is constant, the band-
width is inversely proportional to the Q, which means that
if you raise the Q, the bandwidth will be narrowed. It can be
adjusted from 0.4 to 24.
Touch it to set the gain cut or boost at the center frequency
for the Low/Low-mid/ High-mid/High band separately. It can
be set from -24 to +24 dB.
p. 36