Application Of Burner To Boiler - baltur TBL 85P Manual De Instrucciones De Uso

APPLICATION OF
BURNER TO BOILER
HEAD UNIT ASSEMNLY
• Adjust the position of connector flange 5 by loosening the
screws 6 so that the combustion head penetrates the advised
amount into the combustion chamber as recommended by the
generator's manufacturer.
• Position the seal insulation 3 on the tube unit inserting cord 2
between flange and seal.
• Fasten the Combustion Head unit 4 to the boiler 1 by means
of the stud bolts, washers and the nuts provided 7.
Competely seal the space between the tube unit of the burner
!
and the hole in the refractory panel using suitable materials
to do so.
ASSEMBLYOFVENTILATION SYSTEM
• Position the half-hinge on the burner scroll in line with those on
the combustion head assembly.
• Put the hinge pin 10 in the position considered most suitable.
• Connect the cable switch on to thecorresponding electrodes,
close the hinge, locking the burner by means of screws 11.
COMPLETING BURNER SETUP
• Remove the protective yellow caps from the connectors beneath
the combustion head and close to the solenoid valves.
• Connect the 12 light oil pipes provided with the burner to their
corresponding connectors, making sure they are properly sealed.
10 / 30
0006081325_201409