Pioneer PDP-6072HD Manual De Instrucciones página 22

Preparation
05
1. Attach the speaker mounting fittings to the
rear of the Plasma Display.
• Attach the fittings for right and left sides to the bottom
right and left on the rear panel of the Plasma Display
using the supplied screws.
Speaker mounting screw
(M5 x 10 mm)
"L" is inscribed
("R" is inscribed on
the fitting for the
right side).
3. Fit the speaker to the mounting fittings in the correct direction.
• Be sure not to mount the speaker upside down.
CAUTION
• To avoid any damage to
the speaker and/or table
top stand from striking
against each other, fit the
speaker to the mounting
fittings while confirming
their locations. As you
may easily strike the
stand, use the protective
sheet in which the
speaker was wrapped
between the speaker and
stand.
• When the speaker
mounting fittings do not
fit the grooves at the rear
of the speaker, adjust the
insertion angle.
For illustrative purposes, the table
top stand is not presented here.
22
En
➀ Tighten the screw in
the upper screw hole
first.
➁ Then, tighten the
screw in the screw
hole right under the
upper hole.
Speaker mounting fitting for the left side
(the fitting method is the same as the
fitting for the right side.)
Insert the speaker mounting
fittings into the grooves at the
rear of the speaker.
2. Attach the center fitting to the lower center
on the rear panel of the Plasma Display.
• Attach the center fitting to the lower center on the rear
panel of the Plasma Display using the two supplied
screws.
➁ Then, tighten the screw
in the oval-shaped
screw hole.
Speaker mounting screw
(M5 x 10 mm)
Speaker mounting fitting for center
NOTE
• See page 24 for speaker mounting procedures when using
the hung on wall unit.
The bottom side of the speaker has a round corner
when viewed from the front side of the Plasma Display.
➀ Tighten the screw in the
round-shaped hole first.
Sheet
Front side of the
speaker
The upper side of the speaker
does not have a round corner.