Watching An Image From A Personal Computer; Connecting A Personal Computer; Displaying An Image From A Personal Computer - Pioneer PDP-6072HD Manual De Instrucciones

Enjoying through External Equipment
Switching the optical audio signal type
Set up for the DIGITAL AUDIO output terminal (OPTICAL),
depending on your AV receiver.
1
Press HOME MENU.
2
then ENTER)
Select "Option". ( /
3
Select "Digital Audio Out". ( /
4
Select "Dolby Digital" or "PCM". ( /
Item Description
Dolby Digital For Dolby Digital encoded signals, outputs in the
(factory default) Dolby Digital format. For PCM encoded signals,
outputs in the PCM format.
PCM Always outputs in the PCM format regardless of the
types of signals.
5
Press HOME MENU to exit the menu.
Watching an image from a personal
computer

Connecting a personal computer

Use the PC terminals to connect a personal computer.
NOTE
• The PC input terminals are DDC2B-compatible.
• Plug & Play may not correctly function, depending on the
personal computer in use.
Plasma Display (rear view)
AV cable with a mini plug
(commercially available)
(When PC audio is
connected)
Personal computer
then ENTER)
then ENTER)
Viewed from below of
the Plasma Display
RGB cable
(commercially
available)

Displaying an image from a personal computer

When connected to a personal computer, the input signal type
is automatically identified. If the personal computer image
does not come in clearly, you may need to use Auto Setup. See
page 68.
To watch an image coming from the personal computer, press
PC on the remote control unit or press INPUT on the Plasma
Display to select "PC".
NOTE
• The PC terminals cannot be used for audio-visual
equipment.
Signal names for 15-pin mini D-sub connector
5 4
10 9
15 14
(front view)
Pin No. Signal name
1 R
2 G
3 B
4
Not connected
5 Not connected
6 GND (ground)
7 GND (ground)
8
GND (ground)
9 +5V
10 GND (ground)
11
Not connected
12 SDA
13 HD
14 VD
15
SCL
NOTE
• A Macintosh adaptor may be required for use with some
Macintosh computers.
3 2 1
8 7 6
13 12 11
12
75
En