When Using The Hung On Wall Unit - Pioneer PDP-6072HD Manual De Instrucciones

Preparation
05

When using the hung on wall unit:

First install the Plasma Display on the wall with only the
speaker mounting fittings and speaker cable attached to the
display, and then attach the speaker.
1. Connect the supplied speaker cables to the
back of the Plasma Display.
*
Speaker mounting screw
(M5 x 10 mm)
5. Tighten from below using the supplied screws
(3 locations).
Attach the speaker in the center first, and then both sides with
the supplied screws.
CAUTION
• Be careful not to be injured by the speaker mounting fittings
during installation or cable wiring.
24
En
2. Place the Plasma Display on the mounting
fittings of the hung on wall unit.
For details, refer to the instruction manual supplied with
the hung on wall unit.
3. Connect the other end of the speaker cables
to the speaker.
4. Place the speaker on the speaker mounting fittings in the
correct direction.
*
Speaker mounting screw
(M5 x 10 mm)
*
Speaker mounting screw
(M5 x 10 mm)
The screw hole at the bottom of the
speaker mounting (indicated with an
asterisk) is not used when the Plasma
Display is installed on the wall.