TOHATSU M 25H Manual Del Propietário página 31

For quantities of engine oil and gasoline to
be pre-mixed, refer to table in previous
page.
When portable fuel tank is used for
operation of outboard motor(s):
1
Pour engine oil into fuel tank, and then,
gasoline.
2
Put cap on the tank, and close tightly.
3
Close air vent plug tightly.
ENOW00938-0
WARNING
Loose cap or air vent plug can cause leak
of fuel during shaking the tank.
4
Shake the tank to mix engine oil and
gasoline well and even.
When fuel tank built in the boat is
used for operation of outboard
motor(s):
1
Prepare separate fuel container for pre-
mixing.
ENOF01709-0
PRE-OPERATING PREPARATIONS
2
Pour engine oil into fuel container, and
then, gasoline.
3
Put cap on the container, and close
tightly.
4
Shake the container to mix engine oil
and gasoline well and even.
5
Pour the mixture into fuel tank.
ENON00922-0-0
Notes
It is recommended to pre-mix by using
separate fuel container. Attempting to
pre-mix in the fuel tank built-in the boat
can make the mixture uneven.
If built-in fuel tank is used for mixing,
pour engine oil into the tank little by little
while putting gasoline into the tank.
29
6