To Clean The Product; To Clean The Cooling Fins; To Clean The Battery - Husqvarna DURATIQ XP6 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Maintenance
Replace the air filters.
Examine the spark plug.
Do the service on the drive system for grinding discs.
Do a check of the connection between chassis and grinding head.

To clean the product

CAUTION: A blocked air intake decreases
the performance of the product and can
cause the engine to become too hot.
Remove blockage from all air openings. The product
must always have sufficiently cool temperature.
Do not use chemicals to clean the product.
Do not clean electrical components with water.
Do not clean the carbon monoxide detector with
water or use water near the detector. The filter in the
carbon monoxide detector is sensitive.
Always clean all the equipment at the end of the
work day. Clean the components at the bottom
surface of the grinding head with a high-pressure
washer.
CAUTION: Do not point the high-
pressure washer directly at seals or
connection points.

To clean the battery

CAUTION: Do not clean the battery with
water.
Clean the battery terminals with compressed air or
use a soft and dry cloth.
Clean the surfaces of the battery with a soft and dry
cloth.
1268 - 002 - 25.05.2020
Daily

To clean the cooling fins

1. Clean the oil cooling fins with a brush or with
compressed air.
2. Remove the speed control cable.
Each
12
Week-
Each
month
ly
100 h
s or
250 h
X
X
O
*
25

Publicidad

Tabla de contenido
loading

Tabla de contenido