To Replace The Air Filters; To Replace The Oil Filter - Husqvarna DURATIQ XP6 Manual Del Usuario

2. Remove the oil drain hose from the plastic clip and
remove the oil drain plug.
3. Drain the oil into the container.
4. Attach the oil drain plug and tighten it.
5. Install the oil drain hose in the plastic clip.
6. Fill with new oil. Refer to
36 .
7. Start the engine and let it run at idle speed for 3
minutes.
8. Stop the engine and make sure that the oil drain plug
does not leak.
9. Do a check of the oil level. Refer to
the oil level on page 27 .
Note: For safe disposal of used engine oil, refer to
Disposal on page 34 .

To replace the oil filter

1. Drain the engine oil, refer to
oil on page 27 .
2. Turn the oil filter counterclockwise to remove it.
28
Technical data on page
To do a check of
To replace the engine
3. Lightly lubricate the rubber seal on the new oil filter
with new oil.
4. To attach the oil filter, turn it clockwise until the
rubber seal is in position. Tighten the oil filter ⅔ turn
more.
5. Fill with new oil. Refer to
36 .
6. Start the engine and let it operate at idle speed for 3
minutes.
7. Stop the engine and make sure that the oil filter does
not leak.
8. Do a check of the oil level.

To replace the air filters

CAUTION: Do not operate the product with
the air filters removed.
Note: Do not clean the air filters. Replace the air filters
when it is necessary.
1. Open the 2 clamps (A) of the air filter housing (B)
and remove the air filter housing.
A
B
2. Replace the outer air filter (C) and the inner air filter
(D).
D
C
Technical data on page
1268 - 002 - 25.05.2020