To Adjust The Weights; To Set The Headlights On And Off - Husqvarna DURATIQ XP6 Manual Del Usuario

Weights
The product has 1 weight on each side of the product. If
the product is heavy to operate, adjust the weights to
change the pressure on the grinding head. The weights
must be adjusted to the same position on the right and
the left side. The weights has 4 positions:
• Position 1: Maximum pressure on the grinding head.
This position increases the operation effect. This
position is also used when you set the product in
transport position.
• Position 2: Less pressure than position 1 on the
grinding head.
• Position 3: Standard pressure on the grinding head.
22
• Position 4: Minimum pressure on the grinding head.
This position is also used when you tilt the product to
servicing position.

To adjust the weights

WARNING: Be careful when you adjust the
weights. The moving parts can cause injury.
WARNING: Always make sure that the
weight lock locks correctly when the weights
are put in the selected position.
1. Fold out the weight handle (A).
C
2. Pull out the weight lock pin (B) and move the weight
to a selected position (C) with the weight handle.
Weights on page 22 .
Refer to
3. Release the weight lock pin to lock the weight in the
selected position.
4. Fold in the weight handle.

To set the headlights on and off

2 headlights can be installed on the product, 1 at the
front and 1 at the rear.
1. Install the headlights on an applicable position on the
product. The rear side of the headlights has a
magnet.
A
B
1268 - 002 - 25.05.2020