Introduction..................................................................... 2
Safety..............................................................................9
Operation...................................................................... 13
Maintenance................................................................. 23
Owner responsibility
WARNING: Processing of concrete and
stone by methods such as cutting, grinding
or drilling, especially during dry operation,
generates dust that comes from the material
being processed, which frequently contains
silica. Silica is a basic component of sand,
quartz, brick clay, granite and numerous
other minerals and rocks. Exposure to
excessive amount of such dust can cause:
Respiratory disease (affecting your ability to
breathe), including chronic bronchitis,
silicosis and pulmonary fibrosis from
exposure to silica. These diseases may be
fatal;
Skin irritation and rash.
Cancer according to NTP* and IARC* */
National Toxicology Program, International
Agency for Research on Cancer.
Take precautionary steps:
Avoid inhalation of and skin contact with
dust, mist and fumes.
Wear and ensure that all bystanders wear
appropriate respiratory protection such as
dust masks designed to filter out
microscopic particles. (See OSHA 29 CFR
Part 1926.1153)
To minimize dust emissions, use water to
bind the dust, when feasible. If dry operation
is necessary, use an appropriate dust
extractor.
It is the owner's/employer's responsibility that the
operator has sufficient knowledge about how to use the
product safely. Supervisors and operators must have
read and understood the Operator's Manual. They must
be aware of:
•
The product's safety instructions.
2
Contents
Troubleshooting............................................................ 30
Technical data.............................................................. 36
Introduction
•
The product's range of applications and limitations.
•
How the product is to be used and maintained.
National/Local regulations could restrict the use of this
product. Find out what regulations are applicable where
you work before you start using the product.
The engine exhaust from this product
contains chemicals known to the State of
California to cause cancer, birth defects
CALIFORNIA AIR RESOURCES BOARD (CARB)
Note: The machine is considered a preempt Off-Road
Application as relating to CARB standards. The U.S.
EPA has sole authority to establish emission standards
for preempt construction equipment.
Product description
The product is a floor grinder for surfaces of different
hardness. The product has a propane engine.
Intended use
The product is used to grind surfaces of materials with
different hardness such as natural stone, terazzo and
concrete. Also use the product to grind cover materials
such as epoxy and glue. The finish of the surface can be
rough or smooth. The product can be used for dry
grinding and wet grinding. Do not use the product for
other tasks.
The product is used in commercial operations by
professional operators.
WARNING
or other reproductive harm.
1268 - 002 - 25.05.2020