To Replace The Diamond Tools - Husqvarna DURATIQ XP6 Manual Del Usuario

• Full set of diamond tools: This configuration is
applicable for a flat floor finish.
• Half set of diamond tools: This configuration is
applicable when a flat floor finish is not necessary.

To replace the diamond tools

WARNING: Use protective gloves, as
diamond tools can become very hot.
WARNING: Use approved respiratory
protection when you replace the diamond
tools. The dust below the grinding head is
dangerous to your health.
WARNING: Use the dust extractor when you
replace the diamond tools. The dust
extractor will decrease the dust that can
cause health problems.
CAUTION: All the grinding discs must
always have the same number and type of
diamonds. The height of the diamonds must
be the same on all grinding discs.
14
1. Push the ON/OFF button (A) on the control panel
stop the product.
B
2. Push the emergency stop button (B) on the control
panel.
3. Set the handle in servicing position. Refer to
positions on page 16 .
4. Adjust the weights to a rearward position. Refer to
To adjust the weights on page 22 .
5. Hold the handlebar and with one foot on the weight
tilt the product rearward. Tilt the product until the
handlebar is on the floor.
WARNING: Make sure that the product
is in a stable position before you replace
the diamond tools.
6. Put on protective gloves.
A
Handle
1268 - 002 - 25.05.2020