Conditions For Use - Invacare Texas Manual Del Usuario

For your safety, assure you of the good locking of the
backrest on the frame and verify the assembling by firing firmly
the backrest. If this last is staying in position, you can use your
lift-out chair.
Otherwise, restart the procedure of assembling of the back-
rest. If you doubt the good locking of the backrest, do not use
the lift-out chair and contact your distributor, there is a risk of
fall in case of bad assembling of the backrest.
Nota: To disassemble, position the backrest horizontally, pull
outwards on the 2 red tabs (A) and take out the backrest.
2) Readying the armchair for use
- Check that the remote control is working by testing the
EN8
functions.
- Put the armrest guards in place and install the head and lum-
bar support cushions.
- Adjust the 4 feet of the frame to ensure that the armchair is
perfectly stable on the floor.
There is a location in the power supply box for two 9V
batteries (B, not included). Both batteries allow a descent in
case of power failure (needs to be replaced after each use).

5.3 Conditions for use

The Lift-out chair has been designed for use in the following
conditions:
Temperature
Humidity
Use of the armchair is not recommended if there is a risk
of storms.
A
Min Max Optimal
5°C 40°C 20°C
90% 60%
B