Before Starting Work - EMAK Oleo-Mac OM 106 Manual De Uso

(continued)
INTERVAL
AFTER 50 HOURS
AFTER 100 HOURS
MONTHLY
BEFORE THE
SEASON
AFTER THE
SEASON
(PUTTING OUT OF
OPERATION)
Explanations for table:
1 = Replace the oil more frequently if the riding mower is under greater load or works in outdoor temperatures around 35°C or higher.
2 = If the machine works in a dusty environment, perform the inspection more frequently.
3 = Perform the inspection more frequently if the machine works in a sandy environment.
4 = Perform the inspection more often if a new belt has been fitted.
N = Manual of the manufacturer, supplied with the machine.
6.2 | DAILY CHECKS AND MAINTENANCE
Before starting any maintenance or repair works, thoroughly reacquaint yourself with all instructions, restrictions and
recommendations in this user's manual.
Always remove the key from the ignition and disconnect the spark plug cables before performing any cleaning, maintenance or
repairs.
When working use suitable work clothing and work footwear. Use suitable gloves when handling a mowing blade or for activities
where there is a risk of cuts.
Avoid spilling fuel, oils or other harmful substances.
Do not perform any major repairs if you do not have the necessary tools and a good knowledge about repairs of
combustion engines!
Dispose of used oil, fuel or other hazardous substances and materials in accordance environmental protection regulations in force.

6.2.1 BEFORE STARTING WORK

► INSPECTION OF TYRE PRESSURE
Maintain the prescribed tyre pressure and check it regularly. Maintaining the prescribed tyre pressure is important for even mowing.
Different pressure values may cause difficulty in driving, or even loss of control over the machine.
The air pressure in the front and rear tyres must be in the range 80 - 140 kPa, whilst the differences between individual tyres may
be ± 10 kPa.
► INSPECTION OF THE OIL LEVEL IN THE ENGINE
Park the riding mower on a horizontal surface. Open the hood and unscrew the cap of the filling opening. Screw out the oil dipstick,
wipe it dry, reinsert it and screw in. Then again screw it out and take the oil level reading.
The oil level must be between the two marks on the dipstick. If it is not, fill up with motor oil so that it reaches the "FULL" mark.
Further details about checking and fi lling of oil are included in a separate user's manual supplied by the engine's manufacturer.
► INSPECTION OF CABLES AND BOLT CONNECTIONS
Visually inspect the condition of cables and manually check the tightness of bolt connections.
ASSEMBLY
Air filter and spark plugs
Lubrication
Engine, transmission,
electromagnetic transmission
Tyres
Mowing deck
Fuel filter
Battery
Travel drive belt
Mowing deck
Front axle and steering
Engine
Cables
Mowing deck
Inspection, replacement if necessary
Lubrication of parts according to lubrication plan
Inspection and adjustment of motion
Inspection of pressure
Inspection of tension of the cogged blade drive belt
Replacement
Inspection of electrolyte and cleaning
Inspection and adjustment
Inspection of tension of the cogged blade drive belt
Inspection of the correct tension of the mowing deck
drive V-belt
Inspection and adjustment of play
Oil change
Inspection of mounting, inspection of quick coupler parts
Cleaning
50
ACTIVITY
1,2
6.3.2
6.4
N
6.2.1
6.3.9
N
6.3.1
6.3.12
6.3.9
6.3.8
6.3.11
6.3.2
6.2.1
6.2.2