After Finishing Work - EMAK Oleo-Mac OM 106 Manual De Uso

► INSPECTION OF WORKING ORDER OF BRAKES
Check that the brakes work properly. Proceed as follows:
} Park the machine on an even surface and turn off the engine.
} Step on the brake pedal and engage the parking brake.
} Using the by-pass lever disengage the rear wheel drive.
} Try to push the machine forward. If the rear wheels rotate, then the brakes need to be serviced. Contact an authorised service
centre to have them adjusted.
► INSPECTION OF THE WORKING ORDER OF SAFETY ELEMENTS
Before every use of the riding mower, check the working order of safety elements:
} switch under the seat
} switch on an attached grass catcher or deflector
} full grass catcher switch

6.2.2 AFTER FINISHING WORK

► SETTING UP THE MACHINE
After finishing mowing, elevate the mowing deck to the highest position and disable the drive for the mowing blades.
Turn off the ignition, step on the brake pedal and secure the machine in position with the parking brake. On machines, where
present, close the fuel supply.
► CLEANING THE MACHINE
Remove all dirt and grass remains from the surface of the tractor, the ejection chute and the mowing deck.
Thoroughly clean the textile sack of the grass catcher. When it is clogged with grass, the ability of the machine to fill the grass
catcher is reduced.
► WASHING THE MACHINE
Before washing, park the machine on a suitable even surface.
} Grass catcher:
- remove the grass catcher from the machine, wash it and allow it to dry naturally.
} Plastic parts on the machine:
- clean using a sponge and soapy water
} Mowing deck:
- wash the inside including the part of the ejection chute
- slide a hose of a suitable diameter on to the fittings on the mowing deck cover. Start the engine, engage the
mowing deck and flush out the mowing deck with a current of water for 10 minutes.
This flushing procedure needs to be performed at the end of every mowing session.
Avoid washing with water in the vicinity of electrical accessories on the control panel, battery, etc.
Do not spray pressurised water on to bearings or pulleys!
We do not recommend cleaning the machine and particularly the mowing deck using pressurised water. This can reduce the
lifetime of bearings and other moving parts!
6.3 | REGULAR CHECKS, MAINTENANCE AND ADJUSTMENT
6.3.1 BATTERY
Correct and regular maintenance of the battery will extend its lifespan. Therefore regularly check its condition according to the
manual supplied by the battery's manufacturer.
} Keep the battery contacts clean. If dirt accumulates on them, or they are rusty, clean them according to the recommendations of
the battery's manufacturer. Interruption of the circuit caused by the oxidation of the contacts may lead to the malfunction of the
recharging function of the engine!
} Regularly check the condition of the electrolyte. The level must be in the range MIN - MAX. In the event of
filling up the electrolyte, use only distilled water.
} A flat battery needs to be recharged as soon as possible, otherwise its cells may be irreparably damaged.
} It is always necessary to charge the battery before:
- first use
- when not planning on using it for a long time
- before starting up after a longer break
} If it is necessary to replace the battery, always use a battery of the same size and type.
51
6.2.2