Vertical Mitre Angles; Special Cutting Position; Cutting Depth Limiter - Festool KAPEX KS 120 Manual De Instrucciones

14
14.2
14.3
Standard horizontal mitre angles
The following preset mitre angles are available:
left: 0°, 15°, 22.5°, 30°, 45°
right: 0°, 15°, 22.5°, 30°, 45°, 60°
– Move the machine to working position.
– Pull the clamp lever (14.3) upwards.
– Push the stop lever (14.2) downwards.
– Turn the saw base to the desired mitre angle.
– Release the stop lever. The stop lever must latch
into place.
– Push the clamp lever downwards.
Other horizontal mitre angles
– Move the machine to working position.
– Pull the clamp lever (14.3) upwards.
– Push the stop lever (14.2) downwards.
– Turn the saw base to the desired mitre angle.
– Push the clamp lever downwards.
– Release the stop lever.

Vertical mitre angles

– Move the machine to working position.
– Open the clamping lever (15.1).
– Turn the selector switch (15.2) to the desired
setting range (0° - 45°, ± 45°, or ± 47°).
– Swivel the saw unit until the pointer (15.3) indi-
cates the desired mitre angle. You can adjust the
14.1
15.1
15.2
15.3
15.4
vertical mitre angle more accurately using the
fi ne adjustment rotary handle (15.4).
– Close the clamping lever (15.1).

Special cutting position

Apart from the standard position for cutting or
trimming boards/panels, the machine also has a
special cutting position for trimming strip material
up to 120 mm in height.
16.1
– Pull the saw unit forwards.
– Push the lever (16.3) down.
– Slide the saw unit back until the metal bracket
(16.1) hooks into the rear opening on the saw
unit.
– In this position, you can trim strip material
up to 120 mm in height against the fence. The
guiding function and the vertical swivel function
on the circular cross-cut saw are deactivated
however.
– To move the machine back to its normal position,
push the release lever (16.2) and pull the saw
unit forwards. The metal bracket (16.1) unhooks
itself and the lever (16.3) moves back.

Cutting depth limiter

The vertical swivelling range of the saw unit can
be adjusted via the stepless cutting depth limiter,
allowing you to groove or form workpieces.
– Move the machine to working position.
– Move the cutting depth limiter lever (17.1) down
until it slots into position. The saw unit can now
16.2
16.3
17.1
17.2
17.3