TOHATSU EverRun Serie Manual Del Propietário página 48

Ocultar thumbs Ver también para EverRun Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

48
INSPECTION AND MAINTENANCE
Replacing gear oil
 Be sure that outboard motor is secured
to transom or service stand, or acciden-
tal drop or fall of outboard motor could
lead to severe personal injury.
 Be sure to lock outboard motor if it is
tilted up, or accidental fall of outboard
motor could lead to severe personal
injury.
 Do not go under outboard motor tilted
up and locked, or accidental fall of out-
board motor could lead to severe per-
sonal injury.
1
Remove the oil plugs (upper and lower),
and completely drain the gear oil into a
pan.
X40, 50
9
2
Insert the oil tube nozzle into the lower
oil plug hole, and fill with gear oil by
squeezing the oil tube until oil flows out
of the upper plug hole.
X40, 50
Oil tube nozzle
WARNING
WX50
Upper
oil plug
Lower
oil plug
WX50
Upper
oil plug
hole
Lower
oil plug
3
Install the upper oil plug, and then
remove oil tube nozzle and install the
lower oil plug.
X40, 50
Upper
oil plug
Lower
oil plug
CAUTION
Do not reuse oil plug gasket. Always use
new gasket and tighten oil plug properly to
prevent entry of water into lower unit.
Note
If water in the oil, giving it a milky colored
appearance. Contact your dealer.
Note
Use only genuine or recommended gear oil
or, if not available, an API (American Petro-
leum Institute) oil grade of GL5 SAE
#80~SAE#90.
Required volume
: 40, 50 approx. 500mL (16.89 U.S. fluid oz)
: W50 approx. 700mL (23.65 U.S fluid oz)
WX50

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Everrun mx 40d2Everrun mx 50d2Everrun mwx 50d2

Tabla de contenido