Warming Up The Engine - TOHATSU EverRun Serie Manual Del Propietário

24
ENGINE OPERATION
Manual Rope Start - - - in case of
trouble with the Recoil Starter
Wind the starter rope around the flywheel
a few turns. Give it a sharp tug to start the
engine. Use a socket wrench or similar to
get a firm grip on the end of the rope.
Be careful that your clothes or other items
5
do not get caught in the rotating engine
parts.
To prevent accident and injury, do not re-
attach the recoil starter after the engine
has been started using the emergency
starter rope. Be sure to put the top cowl
back on.
Immediately contact an authorized dealer
when reaching shore.
 Be sure that no bystander(s) is within 2
meters from back of starting operator.
 Do not operate the outboard motor with
top cowl removed from the power unit,
or contacting turning flywheel which can
lead to serious personal injury.
WARNING
WARNING

2. Warming up the engine

Before driving the boat, let the engine run
at low speed for approximately three min-
utes to let it warm and allow the oil to cir-
culate through the machine. If the engine is
not warmed up beforehand, the engine life
will shorten greatly. During the warm-up
operation, confirm that cooling water is
discharged from the check port and idle
port.
Idle port
CAUTION
Be sure to warm up engine well before
starting cruise. Operating cold engine can
give damage to it.
Note
Idle speed may be higher during warming
up of engine. If shifted to Forward or reverse
during warming up, it may be difficult to shift
back to neutral. In such case, stop engine,
shift to neutral, and restart engine to warm
up.
Cooling water
check port