Break-In - TOHATSU EverRun Serie Manual Del Propietário

Ocultar thumbs Ver también para EverRun Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

20
PRE-OPERATING PREPARATIONS

3. Break-in

Your new outboard motor and lower unit
require break-in for the moving compo-
nents
according
described in the following time table.
4
Throttle
Position
Speed
Note
Proper break-in allows outboard motor to
deliver it full performance for longer service
life.
Fuel mix ratio for break-in
Gasoline 25: Genuine Engine Oil 1
 25:1 when using genuine engine oil or
the recommended one (TCW3).
to
the
conditions
1-10min
10min-2hrs
Less than 1/2
Idle
throttle
Approx.
3,000 rpm max
CAUTION
Operating the outboard motor without
break-in can shorten service life of the
product.
If any abnormality is experienced during
the break-in:
 Discontinue the operation immediately.
 Have the dealer check the product and
take proper action(s) if necessary.
2-3hrs
3-10hrs
Less than 3/4
3/4 throttle
throttle
Approx.
Full throttle run
4,000 rpm.
allowed for 1 min
Full throttle run
every 10 min
allowed for 2 min
every 10 min
DANGER
Do not operate the outboard motor in
closed area or area with no forced ventila-
tion.
Exhaust gas emitted by this outboard
motor contains carbon monoxide that will
cause death if inhaled continuously. Inhal-
ing the gas initially causes symptoms such
as feeling of sickness, drowsiness and
headache.
During operation of the outboard motor :
 Keep peripheral area well ventilated.
 Always attempt to stay on the windward
side of emission.
After 10hrs
Full throttle
available

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Everrun mx 40d2Everrun mx 50d2Everrun mwx 50d2

Tabla de contenido