Hmi-Ssw05-Rs Start-Up; Keypad Copy Function - WEG SSW-05 Manual Del Usuario

Installation and Operation Manual - SSW-05 Plus
Note
(1) By pressing the
stored automatically and will remain stored until a new value is programmed.
(2) To allow the reprogramming of any parameter (except for P000) it is required to set
P000 = 5. Otherwise you can only read the parameter values, but not reprogram them.
For more details, see P000 detailed description.
19.3.5. HMI-SSW05-RS Installation:
The HMI-SSW05-RS can be installed directly on the panel door 1 to 3mm (0.04in to 0.12in), as shown in the
figure below:

19.3.6. HMI-SSW05-RS Start-up:

After installation (including interconnecting cable), power up the Soft-Starter.
The HMI-SSW05-RS must display "rdy".
To enable the keys

19.3.7. Keypad Copy Function:

The HMI-SSW05-RS keypad still has an additional function: the Keypad Copy Function. This function
is useful when one wants to copy the settings of one Soft-Starter (source Soft-Starter) to another
(target Soft-Starter) or one needs to program several Soft-Starters with the same settings.
This is done as follows: the parameters of the source Soft-Starter are copied to a non-volatile
memory of the HMI-SSW05-RS Keypad, and then from this keypad to another Soft-Starter ("target
Soft-Starter"). The keypad copy function is controlled by the parameter P215.
For further information on this function, refer to detailed parameter description of P215.
key after the reprogramming, the new programmed value will be
Figure 19.5 - HMI-SSW05-RS Installation.
of the HMI-SSW05-RS, is necessary to program P264  1.
and
English-22