Installation and Operation Manual - SSW-05 Plus
11.5. Motor Connection:
U V
W
CORRECT
Attention
Only the motor frame shall be grounded.
12. SSW-05 PLUS SETTING:
12.1. Pedestal Voltage Setting:
Set the pedestal voltage to a value that the motor starts to run as soon as run command is given by
the SSW-05 Plus.
Trimpot for the
pedestal voltage
setting
12.2. Setting of the acceleration ramp time:
Set the value so that the motor accelerates to the rated speed.
Note:
Please consider that in the cases where rated SSW-05 Plus current is equal to the rated
motor current, the SSW-05 Plus can be operated, at maximum, during 10 seconds at 3 x
I
.
N
Trimpot for
the acceleration
Ramp time
setting
12.3. Setting of the deceleration ramp:
This setting should be used only for deceleration of pumps in order to reduce hydraulic shocks.
This setting must be made in order to obtain the best pump performance.
V
U
W
CORRECT
English-10
W
U V
N
INCORRECT
The dot
indicates the
factory default
Trimpot for the
deceleration
Ramp time
setting
W
U V
INCORRECT