Hmi-Ssw05-Rs Description; Use Of The Keypad - WEG SSW-05 Manual Del Usuario

Installation and Operation Manual - SSW-05 Plus

19.3.1. HMI-SSW05-RS Description:

The HMI-SSW05-RS has a LED display with 4 digits of 7 segments, 2 status LEDs and 5 keys.
The figure below shows the front view of the keypad.
Functions of the LED Display:
The LED display shows the parameter number and its value. It also shows the fault codes and
status.
Functions of the "ready" and "run" LEDs:
Ready: On - SSW-05 Plus has been powered, and is waiting for the enable command, or with full
voltage at output.
Flashing - SSW-05 in acceleration or deceleration ramp time.
Run: It is On only when SSW-05 is operating (motor is operating with full voltage).
Basic Functions of the Keys:
- Enable the Soft-Starter (Start);
- Disable the Soft-Starter (Stop). Also resets the Soft-Starter after a fault has occurred;
- Toggles the LED display between parameter number and its value (number/value);
- Increases the parameter number or the parameter value.
- Decreases the parameter number or the parameter value.
Note
In the occurrence of errors when using an HMI-SSW05-RS, the reset of errors must be
done through the key
causes loss of communication of the HMI, resulting in E31. To re-establish the
communication between the HMI and the Soft-Starter it is necessary to detach and to
reconnect the serial cable, or else to power down and to power up the Soft-Starter again.

19.3.2. Use of the keypad:

The keypad is used for programming and operating the SSW-05, allowing the following functions:
- indication of the Soft-Starter status and operation variables;
- fault indication and diagnostics;
- viewing and programming parameters;
- operation of the Soft-Starter (Keys
Led "Run"
Led "Ready"
Figure 19.4 - Front view of the HMI-SSW05-RS.
. Reset through the key present in the frontal of the Soft-Starter
and
English-20
LED
Display
).