Requirements For Conforming Installations; Emc Directive - WEG SSW-05 Manual Del Usuario

23.2. Requirements for Conforming Installations:

23.2.1. EMC Directive:

The following items are required for CE conformance:
1. The Soft-Starters must be installed into closed metallic boxes or panels that have a door only
able to be opened with a tool. A suitable cooling must be provided to ensure that the temperature
will be within the allowed range.
23.2.2. Low Voltage Directive (LVD):
The following items are required for CE conformance:
1. The same as item 1 above.
2. The installation must provide a supply disconnecting (isolation) device. A hand-operated supply
disconnecting device must be provided for each income supply and be near to the equipment.
This device must disconnect the Soft-Starter from the supply when required (e. g. during work on
the eletrical equipment). See EN60204-1, 5.3. Specify the current and voltage of this disconnecting
device according to the data given in the item 6.
Danger
This equipment must not be used as an emergency stop mechanism (See EN60204,
9.2.5.4).
Installation and Operation Manual - SSW-05 Plus
English-31