Connecting Machine To Power Supply - Janome 1200D Manual De Instrucciones

Connecting Machine to Power Supply

The power switch should be off. Before connecting the
power cord/foot control, make sure the voltage and
frequency shown on the machine are identical to your
electrical power. Insert the machine/foot control plug
into the machine socket and the power supply plug into
the wall outlet.
For Your Safety
1. While the machine is in operation, always keep your
eye on the sewing area and do not touch any
moving parts – needle(s), handwheel, upper knife,
loopers, etc.
2. Always turn off the power switch and unplug the
machine from the power supply:
when leaving the machine unattended
•
when attaching or removing parts
•
when cleaning the machine.
•
3. Do not place anything on the foot control.
Operating Instructions for USA/Canada
This appliance has a polarized plug (one blade wider
than the other). To reduce the risk of electric shock, this
plug is intended to fit in a polarized outlet only one way.
If the plug does not fit fully in the outlet, reverse the
plug. If it still does not fit, contact a qualified electrician
to install the proper outlet. Do not modify the plug in
any way.
Must use foot control YC-482M.
The symbol "O" of a switch indicates the "off" position of
a switch.
16