Stihl FC 100 Manual De Instrucciones página 13

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English / USA
Do not use an edger with incorrect idle
speed adjustment. You may adjust the
idle speed yourself according to the
instructions in your manual. If you
cannot set the correct idle speed, have
your STIHL dealer check your edger and
make proper adjustments or repairs.
Operating instructions
Use only for edging in grass, weeds and
soft green plants.
!
Warning!
During operation, follow all safety
precautions mentioned in the important
safety precaution section of this manual.
Improper use of any edger can cause
serious or fatal personal injury.
In order to reduce risk of eye injury
always wear proper eye protection and
operate product from position where
guards or deflector blocks the line of
sight to the cutting tool.
Stop the engine whenever you leave the
operating position.
12
Maintenance, Repair and Storing
Maintenance, replacement, or repair
of the emission control devices and
systems may be performed by any
nonroad engine repair establishment
or individual. However if you claim
warranty for a component which has
not been serviced or maintained
properly or if nonapproved
replacement parts were used, STIHL
may deny warranty.
Use only identical STIHL replacement
parts for maintenance and repair. Use of
parts manufactured by others may
cause serious or fatal injury.
Follow the maintenance and repair
instructions in the appropriate section of
your owner's manual. Please refer to the
maintenance chart at the last pages of
this manual.
!
Warning!
Always stop the engine, disconnect the
spark plug lead and make sure that the
cutting tool is stopped before doing any
maintenance or repair work or cleaning
the edger.
Keep lead away from spark plug to
reduce the risk of unintentional starting.
Never attempt to make any adjustments
while the engine is running (except
where specifically recommended in this
manual).
Do not attempt any maintenance or
repair work not described in your
owner's manual. Have such work
performed at your STIHL service shop
only. Do not modify the engine governor
or overspeed the engine.
Never repair damaged cutting
attachments by welding, straightening or
modifying the shape. This may cause
parts of the cutting tool to come off and
result in serious or fatal injuries.
Check condition of cutting tool at regular
short intervals. If behavior of tool
changes, check it immediately for
tightness or any signs of cracks in
particular. Replace damaged or dull
cutting tools immediately, even if they
have only superficial cracks.
Check fuel filler cap for leaks at regular
intervals. Use the specified spark plug
and make sure it and the ignition lead
are always in good condition.
FC 100

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido