Replacing The Edger Blade; Inspections And Maintenance By Dealer - Stihl FC 100 Manual De Instrucciones

English / USA
3
4
Fitting the skirt
: Push the skirt (3) into the slot in the
deflector until it can be engaged on
the lug (4).
: Fit the washer on the screw.
: Insert screw and tighten it down
firmly.
32

Replacing the Edger Blade

1
A
B
C
A bent or cracked blade must not be
straightened or welded – it may shatter.
Such blades must be replaced – see
"Fitting the Edger Blade".
STIHL recommends you use only
genuine STIHL edger blades – see
"Special Accessories".
: Replace the blade (1) when its
length (A) is no longer sufficient to
maintain the necessary ground
clearance (B) and obtain the
required depth of cut (C).
To avoid out-of-balance:
check blade on a STIHL balancer –
see "Special Accessories".
Do not resharpen the blade!
Inspections and
Maintenance by
Dealer
Fuel pickup body in tank
: Have the pickup body in the fuel
tank replaced every year.
STIHL recommends that maintenance
and repair work be carried out only by
authorized STIHL dealers.
FC 100